Environmental protection hydraulic station maintenance and repair
The performance of the environmental protection hydraulic station is relatively stable and reliable, but it also needs maintenance and maintenance during daily use. If it is improperly maintained, it will also cause various problems. Therefore, we must master the correct maintenance methods and ensure that the environmental protection hydraulic station is normal. Use can make our daily work smoothly.
First of all, it should be noted that the entire operation status of the eco-hydraulic station is regularly checked and special attention must be paid to the application conditions used in the system. It is mainly to ensure that the environment within the system is clean and no foreign matter can enter the hydraulic system. If it is found that the oil is dirty, it should be immediately filtered using a filter. If the oil deteriorates, it needs to be replaced in time.
Secondly, if there is a need for proper adjustment of the environmental protection hydraulic station at work, after the adjustment, the handles of the valves concerned shall not be arbitrarily turned to prevent the normal operation of the hoist brake system. In addition, staff need to regularly check the valves on the safety brake device and the connection of the various screws.
In general, during the use of environmentally friendly hydraulic stations, the staff must regularly filter the hydraulic oil, which is usually filtered once every six months. In particular, note that even new oils do not represent truly clean oil, so they must be filtered before being injected into the system. At the same time, it is also necessary to regularly clean the screen oil filter and clean it at least once every six months.
Finally, if it is necessary to replace the tubing in the hydraulic station, after the new tubing has been welded, pickling should be performed first. Otherwise, the cleanliness of the entire system may be affected.
Related Industry Knowledge